Fire Scene Evidence Collection Guide
Wood
Stair Treads
Detailed Procedure:
If the treads are covered with carpet, follow the procedure for collecting carpet. If the stair treads are wood, follow the procedure below.
-
Select a productive sampling area. Productive sampling areas include:
-
Within an area of ignitable liquid indicators, such as a suspected pour pattern
-
In an area where ignitable liquid may collect, such as the lowest point on the grade
-
Edge of a burn pattern or suspected pour pattern
-
At junctures with furniture and walls
-
Joints
-
Vertical grain
-
On stair treads at the joint between riser and tread
-
-
Select appropriate new or properly cleaned tools, such as a chisel and mallet, to cut out the sample.
-
Select a new, metal paint can container.
-
Photograph the sampling area.
-
Wear new, unused, clean latex or nitrile gloves.
-
Use the chisel and mallet to break into the wood, preferably ½ inch on either side of the joint between the riser and the tread and up to the joint, as liquids tend to collect in seams. Break out a wood sample that includes the material in the seam and directly underneath the seam (include subfloor if possible).
-
Place the sample in the paint can. If the sample is large, break it into smaller pieces to fit into the container. Make sure to leave 1/3 headspace in the can.
-
Clean the lip of the can using a clean screwdriver or other suitable tool.
-
Gently tap the top of the lid with a clean rubber mallet to seal it. Do not dent the can because it may compromise the seal.
-
Seal the container with evidence tape. Initial and date the tape.
-
If possible, collect a comparison sample from a location not within the ignitable liquid pattern and not in room of origin. Collect the comparison sample in a separate container using new gloves and a new or properly cleaned tool. A comparison sample for ignitable liquids testing will help the laboratory exclude compounds occurring naturally in the wood floor. This sample should be collected in a separate container.
-
Label each container with identifying information, including case number, date, exhibit number, a brief description including recovery location, and your name.
-
Store the item(s) in a secure location, such as a locked evidence van or your vehicle, until you are able to transport it to the laboratory.
Laboratory examination of stair treads for ignitable liquids:
Stair tread materials can be tested for ignitable liquids using gas chromatography mass spectrometry. This test can determine the classification of the ignitable liquid.
Source:
interFIRE. "Evidence Sampling for Ignitable Liquids Testing." Online Training Module, 2013: